The basic kit comes with:
- 1 - QRUQSP CS-101 Circuit Board
- 6 - Terminal Screw Blocks
- 1 - CM108 Sound Card
- 2 - Audio Isolation Transformers
- 1 - DC-DC 5 Amp Step Down
- 2 - 1x40 Male Header Pins
- 1 - 2x20 Male Header Pins
- 1 - 2x20 Female Header Pins Tall
- 1 - PC817 Optocoupler
- 1 - 330 Ohm Resistor
- 2 - 10K Ohm Resistors
- 6 - Jumper Caps
- 1 - 100nF Capacitor
- 1 - 10K Potentiometer
- 1 - 100K Poteniometer
- 1 - Audio Cable
- 2 - USB Extenders
- 3 - Push Buttons & Caps (Red, Blue, Green)
- 1 - 8 Pin Dip Socket
- 1 - DS1307 Real Time Clock
- 1 - 32.768 Khz Crystal
- 1 - CR2032 Battery Holder
- 8 - Nylon M2.5 5mm Screws
- 8 - Nylon M2.5 18mm Spacers
- 1 - BME280
- 1 - 4 Pin Male Female Cable
Note: You must provide the following items:
- Radio
- Radio Interface Cable
- Raspberry Pi 2, 3, 4, Zero W
- SD Card
- CR2032 Battery
- 13.8 Volt Power Supply or Raspberry Pi Power Supply
- RTL-SDR Dongle & 433.92 Mhz Antenna
If you are interested in purchasing a kit, please contact us.