Hardware - Kits - QRUQSP Basic Kit

The basic kit comes with:

  • 1 - QRUQSP CS-101 Circuit Board
  • 6 - Terminal Screw Blocks
  • 1 - CM108 Sound Card
  • 2 - Audio Isolation Transformers
  • 1 - DC-DC 5 Amp Step Down
  • 2 - 1x40 Male Header Pins
  • 1 - 2x20 Male Header Pins
  • 1 - 2x20 Female Header Pins Tall
  • 1 - PC817 Optocoupler
  • 1 - 330 Ohm Resistor
  • 2 - 10K Ohm Resistors
  • 6 - Jumper Caps
  • 1 - 100nF Capacitor
  • 1 - 10K Potentiometer
  • 1 - 100K Poteniometer
  • 1 - Audio Cable
  • 2 - USB Extenders
  • 3 - Push Buttons & Caps (Red, Blue, Green)
  • 1 - 8 Pin Dip Socket
  • 1 - DS1307 Real Time Clock
  • 1 - 32.768 Khz Crystal
  • 1 - CR2032 Battery Holder
  • 8 - Nylon M2.5 5mm Screws
  • 8 - Nylon M2.5 18mm Spacers
  • 1 - BME280
  • 1 - 4 Pin Male Female Cable

Note: You must provide the following items:

  • Radio
  • Radio Interface Cable
  • Raspberry Pi 2, 3, 4, Zero W
  • SD Card
  • CR2032 Battery
  • 13.8 Volt Power Supply or Raspberry Pi Power Supply
  • RTL-SDR Dongle & 433.92 Mhz Antenna

We now have Pre-Orders open, you can purchase from the Canadian or United States shops:

US Store
Canadian Store